Daily Archive: December 16, 2015

Dec 16 2015

X-Carve: Finding Your Own Wiring And Terminal Blocks

Categories:

December 16, 2015

Like I mentioned in the ordering post, I though I had some 18/4 shielded wire lying around, and even if I didn’t how expensive could it be to purchase some? Well, I scavenged through all of my stuff and only found a whole bunch of unshielded …

Permanent link to this article: http://workshop.electronsmith.com/content/x-carve-finding-your-own-wiring-and-terminal-blocks/

Dec 16 2015

X-Carve: Choosing To Make Your Own Wasteboard

Categories:

CNC, X-Carve

by benjamen

December 16, 2015

For the 1000mm X-Carve, the wasteboard costs $128. I figured I could save most of that money by making my own. From what I figured I’d need a 4×4′ sheet of 3/4″ MDF, which would be less than $20. Instead of using threaded inserts and special hold downs, I’d cut …

Permanent link to this article: http://workshop.electronsmith.com/content/x-carve-choosing-to-make-your-own-wasteboard/