Category Archive: Table Saw Cart

Oct 11 2012

Offset Turning

A few months ago I rewatched an episode of the Woodwright’s Shop where Roy Underhill made some oval handles using offset turning. At the time I thought this is something I’d to try on my lathe. So when I needed drawer pulls for my table saw cart, I figured this would be the perfect opportunity to give …

Continue reading »

Permanent link to this article: https://workshop.electronsmith.com/content/offset-turning/

Oct 09 2012

Table Saw Cart: Inlet Plug

The cord on my table saw is always getting in the way. Since it comes out underneath the left side of the saw and I usually plug the table saw in on the front right side, the cord is lying at my feet when I’m using the saw — a real workshop hazard. Also since …

Continue reading »

Permanent link to this article: https://workshop.electronsmith.com/content/table-saw-cart-inlet-plug/

Sep 19 2012

Table Saw Cart: Stationary And Mobile Base

Originally I had just planned to use locking castors on the base of the table saw cart, but after I actually mounted the castors, I immediately ran into two problems. Since this cart is much lighter than my previous cart, it wanted to slide around the floor when I was using it. …

Continue reading »

Permanent link to this article: https://workshop.electronsmith.com/content/table-saw-cart-stationary-and-mobile-base/

Sep 15 2012

Table Saw Cart: The Carcass

Since I can buy a whole stick of 8′ of “quality” grade 1×4 pine for less than I can buy 1 board foot of any other material, I decided to make the carcass of the table saw stand using pine and 1/4″ plywood. Yes, pine is a softer wood, but I’m not …

Continue reading »

Permanent link to this article: https://workshop.electronsmith.com/content/table-saw-cart-the-carcass/

Sep 12 2012

Planning A New Table Saw Cart

I’ve recently discovered the joys of having all of a tool’s accessories within reach of the tool. In between projects, I’ve been slowly reorganizing my shop so I don’t have to walk across the shop three times to perform a simple task. My latest focus has been my table saw, it currently sits atop a quickly …

Continue reading »

Permanent link to this article: https://workshop.electronsmith.com/content/planning-a-new-table-saw-cart/