Category Archive: Phenolic Coated Plywood

Jun 19 2012

Drill Press Work Holder

I saw this idea for a work holder by +Christopher Landy over on Google+ — it’s not the first time I’ve seen something like it, but it kicked me in the butt to make one for my drill press table. Rather than a clamping the work piece to the table like …

Continue reading »

Permanent link to this article: https://workshop.electronsmith.com/content/drill-press-work-holder/

Jul 06 2011

New Router Table Fence: The Face

With the carcass completed, I turned to working on the phenolic coated plywood face. On the top part of the fence, I have one stationary 32″ piece with a T-slot for attaching featherboards, guards, and stops. Below this stationary piece are two 21″ pieces that slide on t-bolts which can be …

Continue reading »

Permanent link to this article: https://workshop.electronsmith.com/content/new-router-table-fence-face/

Jun 28 2011

New Router Table Fence: The Frame

Since I gave my old router table fence away, I needed to make a fence for my new router table — the old fence was too small for the larger table I built anyway. I didn’t follow any specific set of plans when I made the fence, rather I used the …

Continue reading »

Permanent link to this article: https://workshop.electronsmith.com/content/new-router-table-fence-frame/